Vega VEGAFLEX 61 Operating Instructions Manual page 14

4 Mounting
Socket
14
If possible, avoid sockets. Mount the sensor flush with the vessel top. If
this is not possible, use short sockets with small diameter.
Higher sockets or sockets with a bigger diameter can generally be
used. They simply increase the upper dead band. Check if this is
relevant for your measurement.
In such cases, always carry out a gating out of false signals after
installation. You can find further information under "Setup procedure".
Fig. 6: Mounting socket
When welding the socket, make sure that the socket is flush to the
vessel wall.
1
Fig. 7: Socket must be installed flush
1
Unfavourable installation
2
Socket flush - optimum installation
d
DN40 ... DN150
> DN150 ... DN200
d
2
VEGAFLEX 61 • Profibus PA
h
£ 150
£ 100