Symbols On The Appliance; Description Of The Device; Assembly; Initial Startup - Kärcher K 3 Deluxe Premium Manual

High-pressure gun lock
The lock locks the lever of the high-pressure gun and
prevents the device from starting unintentionally.
Auto-stop function
If the lever of the high-pressure gun is released, the
pressure switch turns off the pump and the high-pres-
sure jet stops. The pump switches on again when the le-
ver is pressed.
Motor circuit breaker
The motor circuit breaker shuts off the device if power
consumption it too high.

Symbols on the appliance

The appliance must not be direct-
ly connected to the public drink-
ing water network.
The high pressure jet must not be
directed at persons, animals, live
electrical equipment or at the ap-
pliance itself.
Protect the appliance against
frost.

Description of the device

The maximum amount of equipment is described in
these operating instructions. Depending on the model
used, there are differences in the scope of delivery (see
packaging).
For the illustrations, refer to the graphics page.
Illustration A
Stand with carrying handle
1
Transport wheel
2
Water connection with integrated sieve
3
Visor
4
Trigger "0/OFF" / "I/ON"
5
Storage / parking position for high-pressure gun
6
Hose guide
7
Transport handle, telescoping
8
Mains connection with mains plug
9
Spray lance dirt blaster for stubborn dirt
10
Vario Power Control spray lance for the most com-
11
mon cleaning tasks
High-pressure gun
12
Button for detaching the high-pressure hose from
13
the trigger gun
High-pressure gun lever
14
High-pressure gun lock
15
High-pressure hose reel
16
Crank handle for hose reel
17
Carrying handle
18
Cable storage hook
19
Detergent suction hose with detergent filter
20
6
Accessory compartment net
21
Water connection coupling
22
Hose coupling
23
Supplied screws and dowels
Illustration B
Stand dowels (2 pieces)
1
Screw M 4x22 (6 pieces)
2
See the illustrations to install the appliance.
Place the screws provided as well as the matching
screwdriver at the ready.
Fit the supplied loose parts onto the device before start-
ing up the device.
Mounting the stand
1. Insert the stand.
Illustration C
2. Insert the 2 dowels into the holes as far as they will
go.
3. Secure the base with 2 screws.
Installing the water connection coupling
1. Screw the water connection coupling onto the water
connection on the device.
Illustration D
Installing the spray lance storage
1. Secure the cover with 4 screws.
Illustration E
Installing the gun holder
1. Assemble the gun holder.
Illustration F
Pushing the high-pressure hose through the
1. Insert the high-pressure hose through the hose
guide.
Illustration G
1. Place the device on a flat and level surface.
2. For devices with a hose reel: Completely unwind the
high-pressure hose from the hose reel.
3. Pull the high-pressure hose all the way forward
through the hose guide.
4. Insert the high-pressure hose into the high-pressure
gun until it audibly clicks into place.
Note
Take care to ensure the correct alignment of the nipple.
Illustration H
5. Check for a secure connection by pulling on the
high-pressure hose.
6. Plug the mains plug into a mains socket.
For the connection values, see the type plate or chapter
Technical data.
Observe the water distribution company regulations.
ATTENTION
Damage through contaminated water
Contamination in the water can damage the pump and
the accessories.
English

Assembly

hose guide

Initial startup

Water supply