Specifying Reproduction Ratio Manually - Toshiba e-STUDIO557 Copying Manual

3 BASIC COPY MODES

Specifying reproduction ratio manually

1
Place paper in the drawer(s).
2
Place the original(s).
3
Press [ZOOM] on the touch panel.
4
Press the buttons below to select the desired reproduction ratio.
[ UP] and [
The reproduction ratio changes by 1% every time either of them is pressed. When you hold either
down, the ratio goes up or down automatically.
One-touch zoom buttons
Select the desired ratio from [400%], [200%], [100%], [50%] and [25%].
When the RADF is used, the maximum ratio available is 200%.
5
Select the desired size, and then press [OK].
If you want to select a paper size other than the following, you need to register the size as
"OTHER". Once you register this size, it will be specified every time you press [OTHER] on the
touch panel.
North America: LD, LG, LT, ST
Other than North America: A3, A4, B4, B5
For how to register, see the following page:
P.59 "Registering paper sizes to "OTHER" size"
Paper sizes can also be registered by pressing the desired drawer button of the equipment
status indication area on the BASIC menu.
60 Enlargement and Reduction Copying
DOWN] buttons