Placing Paper In The Tandem Large Capacity Feeder - Toshiba e-STUDIO557 Copying Manual

1.BEFORE USING EQUIPMENT

Placing paper in the tandem large capacity feeder

1
Pull out the drawer of the tandem large capacity
feeder carefully until it comes to a stop.
Be careful not to touch the slide rails (A in the figure).
This could injure you.
2
Place 2 stacks of paper in the right and left trays
correspondingly.
Fan and jog the paper well before placing it. Place it with its
copy side down. Place one stack of paper in the right-hand tray
(shown as "A" in the figure) with its side touching the right
corner of the tray, and place the other stack of paper in the left-
hand tray (shown as "B" in the figure) with its side touching the
left corner of the tray. Paper can be placed neatly if you divide
stacks into small bundles and pile them up on the two trays
alternately.
Paper in the right-hand tray is used first. When it runs out, paper in the left-hand tray will be
moved automatically to the right-hand tray and fed.
A maximum of 2500 sheets (80 g/m
stack height of the paper must not exceed the line indicated inside the side guides.
P.11 "Acceptable copy paper"
The copy side may be noted on its wrapping paper.
Be careful not to cut your fingers when fanning the paper.
When placing paper, be sure that the center lever is not open. (See the label attached in the
drawer of the tandem large capacity feeder.)
3
Push the drawer of the tandem large capacity feeder straight into this equipment
carefully.
When the drawer is completely inserted, the right-hand tray will move up to the paper feeding position.
Be careful not to let your fingers be caught when pushing the drawer into this equipment.
This could injure you.
2
) (20 lb. Bond) can be placed in the 2 trays. However the
1 BEFORE USING EQUIPMENT
A
A
A
B
Placing Paper 17