Specifying Reproduction Ratio Manually - Toshiba e-STUDIO287CS User Manual

BASIC COPY MODES
5
Select other copy modes as required, and
then press the [START] button on the
control panel.
 Registering paper sizes to "OTHER"
size
If you want to select a size other than the following for the
original size and copy paper size, you need to register the size
as "OTHER" following the procedures below. Once you register
1
this size, it will be specified every time you press [OTHER] on
the touch panel.
North America: LG, LT,ST
Other than North America: A4, B5
Note
• You can register only standard sizes as [OTHER] and
2
cannot register any non-standard sizes.
1
Press [SIZE SETTING] on the touch panel.
3
4
2
Select the desired size.
5
6
The selected size will be registered as an "OTHER" size.

Specifying reproduction ratio manually

1
Place paper in the drawer(s).
2
Place the original(s).
3
Press [ZOOM] on the touch panel.
4
Press the buttons below to select the
desired reproduction ratio.
[ UP] and [
The reproduction ratio changes by 1% every time
either of them is pressed. When you hold either down,
the ratio goes up or down automatically.
One-touch zoom buttons
Select the desired ratio from [400%], [200%], [100%],
[50%] and [25%].
Note
• When the RADF is used, the maximum ratio available
is 200%.
- 46 -
DOWN] buttons