Bypass Copying On Non-Standard Size Paper - Toshiba e-STUDIO557 Copying Manual

2 HOW TO MAKE COPIES

Bypass copying on non-standard size paper

You can use non-standard size paper within the sizes shown on the
right.
1
Place the original on the original glass.
2
Place paper with its copy side up on the bypass tray.
Then align the side guides to the paper length while
holding the tab.
When paper is placed, the menu for bypass copying appears.
The height of the paper must not exceed the indicator on the side guides.
When you use more than one sheet of paper, fan the sheets well before placing them on the
bypass tray. Be careful not to cut your fingers when fanning.
Do not push paper into the entrance of the bypass feeder. This could cause a paper misfeed.
3
Press [CUSTOM PAPER] on the touch panel.
44 Bypass Copying
148 - 432 mm
( 5.8" - 17" )
100 - 297 mm
( 3.9" - 11.7" )