Toshiba e-STUDIO557 Copying Manual page 126

4 EDITING FUNCTIONS
3
Adjust the tab width and shift width.
1) Press [DRAWER] for setting tab paper in the drawer or [BYPASS FEED] for setting it on the bypass
tray.
2) Press [TAB EXTENSION] to adjust the tab width using
3) Press [SHIFT MARGIN] to adjust the shift width using
4) Press [OK].
Though the initial value is set to 13 mm (0.5") for both the tab width and shift width, this can be
changed. For details, refer to the MFP Management Guide.
Range of the tab width and shift width
The tab width and shift width can be set in the following ranges. They are different when the tab paper
is set in the drawer and on the bypass tray.
Drawer
Bypass tray
Measuring the tab width and shift width on the original glass
The tab width and shift width can be measured by the scale on the left and rear side of the original
glass. The marks of the original scale have a 2 mm (0.08") pitch.
Measuring the tab width
Place tab paper on the original glass to measure the tab width.
124 Tab Paper
Tab width
12 - 17 mm (0.4" - 0.6")
10 - 20 mm (0.4" - 0.7")
or .
or .
Shift width
0 - 30 mm (0 - 1.1")
0 - 30 mm (0 - 1.1")
Tab width
Original scale
Aligned with the scale