Region Entrance Detection - HIKVISION DS-2DF5220S-DE4/Ww User Manual

User Manual of Network Speed Dome

6.6.12 Region Entrance Detection

Purpose:
Region entrance detection function detects people, vehicle or other objects which
enter a pre-defined virtual region from the outside place, and some certain actions
can be taken when the alarm is triggered.
Steps:
1. Enter the Region Entrance Detection settings interface:
Configuration> Advanced Configuration> Smart Event> Region Entrance
Detection
2. Check the checkbox of Enable Region Entrance Detection to enable the
function.
Figure 6-59 Configuring Region Entrance Detection
3. Select the region from the dropdown list for detection settings.
4. Click the
5. Click on the live video to specify the four vertexes of the detection region, and
right click to complete drawing.
Repeat the step to configure other regions. Up to 4 regions can be set. You can
click the
6. Set the detection target for the region entrance detection. You can select human,
vehicle, or all (human &vehicle) as the detection target from the dropdown list.
If Human is selected, only human beings will be identified as detection objects
and as well as Vehicle.
7. Click the
Section 6.6.1 Configuring Motion Detection.
© Hikvision
button to start the region drawing.
button to clear all pre-defined regions.
button to set the arming schedule. Refer to Step 2 in
97