Table of Contents
Advertisement
User Manual of Network Speed Dome
5. Draw area.
(1) Click
(2) Click the line to switch to the editing mode.
Click and drag an end to the desired place to adjust the length and angle of
the line. And click and drag the line to adjust the location.
Up to four lines are supported.
6. Configure the parameters for each defense region separately.
Direction: Select the detection direction in the dropdown list, there are A<->B,
A->B and B->A selectable.
Sensitivity: Range [1-100]. The value of the sensitivity defines the size of the
object which can trigger the alarm, when the sensitivity is high, a very small
object can trigger the alarm.
Detection Target: You can select human, vehicle, or all (human &vehicle) as
the detection target from the dropdown list. If Human is selected, only
human beings will be identified as detection objects and as well as Vehicle.
7. Click
to edit the arming schedule for line crossing detection. The
arming schedule configuration is the same as the setting of the arming schedule
for motion detection. Refer to Step 2 in Section 6.6.1 Configuring Motion
Detection.
8. Check the checkbox to select the linkage method, including Notify surveillance
© Hikvision
Figure 6-57 Configuring Line
to draw a line on the image.
95
Advertisement
Table of Contents
