Table of Contents
Advertisement
User Manual of Network Speed Dome
center, send email, upload to FTP, trigger channel, smart tracking and trigger
alarm output are selectable. Please refer to Step 3 in Section 6.6.1 Configuring
Motion Detection.
9. Click
6.6.11 Configuring Face Detection
Purpose:
After the face detection is enabled, a face appears in the surveillance area, it will be
detected and certain actions may be triggered by the detection.
Steps:
1. Check the Enable Face Detection checkbox.
2. (Optional) You can check the Enable Dynamic Analysis for Face Detection
checkbox if you want the detected face get marked with rectangle in the live view.
3. Configure the sensitivity for face detection.
Sensitivity: Range [1-5]. The value of the sensitivity defines the size of the object
which can trigger the alarm, when the sensitivity is high, a very small object can
trigger the alarm.
4. Click
to edit the arming schedule for face detection. The arming
schedule configuration is the same as the setting of the arming schedule for
motion detection. Refer to Step 2 in Section 6.6.1 Configuring Motion Detection.
5. Check the checkbox to select the linkage method taken for the face detection.
Notify surveillance center, send email, upload to FTP, trigger channel, smart
tracking and trigger alarm output are selectable. Please refer to Step 3 in Section
6.6.1 Configuring Motion Detection.
6. Click
© Hikvision
to save the settings.
Figure 6-58 Configuring Face Detection
to save the settings.
96
Advertisement
Table of Contents
