Table of Contents
Advertisement
Connecting to the RemotEye II via HTTP
A web session can be established once the hardware and software have been prepared. Follow these
steps to begin configuration:
1.
Launch the web browser.
2.
Enter the URL for RemotEye II in the browser's address field. For example, http://172.18.1.63.
The home page of the RemotEye II will be displayed once a connection is established (see
Figure 16: RemotEye II HTTP Page on page 42).
Perform the following procedure to setup the RemotEye II using its provided web configuration pages.
Select RemotEye II Management → RemotEye II Configuration to configure RemotEye II.
1.
2.
Click the Become Super User button at the bottom of the screen. Enter TOSHIBA as the login
name and public as the password (case sensitive). Non-DHCP users continue on to step b.
DHCP users may skip steps b to d.
3.
Enter the RemotEye II IP address.
4.
Enter the RemotEye II Gateway address in the network.
5.
Enter the RemotEye II Network Mask of the network.
6.
Enter the IP address of the Primary Time Server and Secondary Time Server in the network.
7.
Click Set Value to save the settings.
Select RemotEye II Management → Date and Time to set date and time.
8.
9.
Enter the appropriate date and time in the specified format.
10.
Click Set Value to save the settings.
Select RemotEye II Management → RemotEye II Control to enable or disable the network
11.
protocols.
42
Figure 16: RemotEye II HTTP Page
RemotEye II User Manual – 50024-014
Advertisement
Table of Contents
