Table of Contents
Advertisement
15
.../upsAlarmUpsSystemOff
16
.../upsAlarmFanFailure
17
.../upsAlarmFuseFailure
18
.../upsAlarmGeneralFault
19
.../upsAlarmDiagnosticTestFa
iled
20
.../upsAlarmCommunicationL
ost
21
.../upsAlarmAwaitingPower
22
.../upsAlarmShutdownPendin
g
23
.../upsAlarmShutdownImmine
nt
24
.../upsAlarmTestInProgress
25
.../upsAlarmPhaseRotation
26
.../upsAlarmReplaceBattSoon Batteries nearing end of expected
27
.../upsAlarmAsyncOperation
28
.../upsAlarmInputOverCurrent UPS reporting Input Overcurrent.
80
The UPS system is off.
Fan failure! UPS system possibly
overheating. Contact Toshiba
authorized service center
immediately.
The failure of one or more fuses
has been detected. Contact your
Toshiba authorized service
center.
A UPS fault condition exists.
Contact your Toshiba authorized
service center immediately.
The result of the last diagnostic
test indicates a failure.
Communication lost between the
RemotEye II and the UPS.
N/A
A UPS output shutdown
command has been issued;
Output will turn off after delay.
The UPS output will be shutdown
in less than 30 seconds due to
previously issued shutdown
command.
A UPS battery test is in progress. Battery test completed.
Input phase rotation is incorrect.
Check input wiring for clockwise
rotation.
lifetime. Contact Toshiba
authorized service center for
replacement.
Inverter can not sync to input.
UPS cannot switch from Run to
Stop until input frequency
stabilizes.
Contact Toshiba authorized
service center for examination of
fault.
N/A
Fans are no longer failing.
N/A
The UPS fault condition has been
removed. Good work.
N/A
Communication has been restored
between the RemotEye II and the
UPS.
N/A
OK
N/A
Input phase rotation has been
corrected.
Battery lifetime monitor has been
reset.
N/A
The cause of the Input
Overcurrent condition has been
removed. The UPS is no longer in
a INOC fault mode.
RemotEye II User Manual – 50024-014
Advertisement
Table of Contents
