Remote Control Problems; Having The Projector Serviced - Eiki EK-610U Owner's Manual

DLP Projector — Owner's Manual
5.
Replace the lamp module.
6.
Put the old lamp back in the projector and have the projector serviced.
Problem: The lamp goes off
1.
Power surges can cause the lamp to turn off. Re-plug power cord. When the Lamp LED is red,
press " " on the built-in keypad or press "
2.
Replace the lamp module.
3.
Put the old lamp back in the projector and have the projector serviced.

Remote Control problems

Problem: The projector does not respond to the remote control
1.
Direct the remote control towards remote sensor on the projector.
2.
Ensure the path between remote and sensor is not obstructed.
3.
Turn off any fluorescent lights in the room.
4.
Make sure that the batteries are installed with the correct polarity.
5.
Replace the batteries.
6.
Turn off other Infrared-enabled devices in the vicinity.
7.
Have the remote control serviced.

having the projector Serviced

If you are unable to solve the problem, you should have the projector serviced. Pack the projector in the
original carton. Include a description of the problem and a checklist of the steps you took when trying to fix
the problem. The information may be useful to service personnel. For servicing, return the projector to the
place you purchased it.
" on the remote control to turn off the projector.
64
— —