Maintenance And Security; Replacing The Projection Lamp - Eiki EK-610U Owner's Manual

Replacing the projection lamp

The projection lamp should be replaced when it burns out. It should only be replaced with a certified
replacement part, which you can order from your local dealer.
Important:
• The projection lamp used in this product contains a small amount of mercury.
• Do not dispose this product with general household waste.
• Disposal of this product must be carried out in accordance with the regulations of your local
authority.
Warning:
Be sure to turn off and unplug the projector at least 30 minutes before replacing the lamp. Failure to do
so could result in a severe burn.
Caution:
• In rare cases the lamp bulb may burn out during normal operation and cause glass dust or shards
to be discharged outward from the rear exhaust vent.
• Do not inhale or do not touch glass dust or shards. Doing so could result in injury.
• Always keep your face away from the exhaust vent so that you do not suffer from the gas and
broken shards of the lamp.
• When removing the lamp from a ceiling-mounted projector, make sure that no one is under the
projector. Glass fragments could fall if the lamp has been burned out.
IF A LAMP EXPLODES
• If a lamp explodes, the gas and broken shards may scatter inside the projector and they may come
out of the exhaust vent. The gas contains toxic mercury.
• Open windows and doors for ventilation.
• If you inhale the gas or the shards of the broken lamp enter your eyes or mouth, consult the doctor
immediately.
Note:
Part number of the Projection Lamp: SP.75A01GC01.
DLP Projector — Owner's Manual
M
aintenance and
53
— —
S
ecurity