Table of Contents
Advertisement
Remote Control Operating Range
The remote control uses infrared transmission to control the projector. It is not necessary to point the
remote directly at the projector. Provided you are not holding the remote perpendicular to the sides or
the rear of the projector, the remote will function well within a radius of about 7 meters (23 feet) and 15
degrees above or below the projector level. If the projector does not respond to the remote control, move
a little closer.
projector and Remote Control buttons
The projector can be operated using the remote control or the buttons on the top of the projector. All
operations can be carried out with the remote control; however, the buttons on the projector are limited in
use.
Inserting the Remote Control batteries
1.
Remove the battery compartment cover as shown in the
illustration.
2.
Insert the batteries with correct polarity (+/-) as shown inside
the battery compartment.
3.
Replace the cover.
Caution:
• Only use AAA batteries (Alkaline batteries are recommended).
• Dispose of used batteries according to local ordinance regulations.
• Remove the batteries when not using the projector for prolonged periods.
DLP Projector — Owner's Manual
9
—
—
Advertisement
Table of Contents
