Add Rcu And Rcu Option Panes - HP xp12000 User Manual

3. For FC configurations, at the RCUs, use Continuous Access XP to configure the Fibre Channel ports
connected to MCUs as RCU target ports (see
4. Connect to the disk array you want to configure as a Continuous Access XP MCU.
NOTE:
perform Continuous Access XP operations. In view mode, you can only view Continuous Access XP
information.
5. Click CA to start Continuous Access XP. The Continuous Access XP main pane appears
page 48).
6. For FC configurations, configure Fibre Channel ports connected to RCUs as initiator ports. For serial
interface configurations, configure serial channel ports connected to RCUs as RCPs. For instructions, see
"Port change
7. Register the RCUs to the current MCU CU image by using the Add RCU pane. Set the options for the
registering RCU by using the RCU Option pane (see
instructions).
Figure 8

Add RCU and RCU Option panes

8. If you plan to create Continuous Access XP Async pairs with P-VOLs in this MCU, configure Async
options using the Async Option pane (see
36 Continuous Access XP for the XP12000/XP10000
You must operate Command View XP or XP Remote Web Console in Modify mode to
operation" on page 76.
"Port change operation" on page 76 for instructions).
"Registering RCUs (Add
"Asynchronous copy option" on page 82 for instructions).
(Figure 15 on
RCU)" on page 66 for