Combining Continuous Access Xp With Other Data Management Operations; Async Option And Add Ct Group Panes - HP xp12000 User Manual

Register the consistency groups to the MCU using the Add CT Group pane (see
groups (Add CT
Figure 9

Async Option and Add CT Group panes

NOTE:
Console, no other actions are required.
When you are finished configuring this MCU, exit the Continuous Access XP main pane, and
9.
disconnect the Command View XP management station from the disk array.
10.If needed, reconnect Performance Advisor to this disk array (running PA at the same time is not
supported).
11.Repeat step 4
configure MCUs, register RCUs, and configure Continuous Access XP async options and consistency
groups, you are ready to begin Continuous Access XP volume pair operations.

Combining Continuous Access XP with other data management operations

Some types of volumes used by non-Continuous Access XP and non-Continuous Access XP Async functions
can also be used as Continuous Access XP and Continuous Access XP Async P-VOLs and S-VOLs.
Table 11 Combining Continuous Access XP Sync and Continuous Access XP Async functions with other
products in disk arrays
Functions and volumes
Volume Manager
LUSE volume
Business Copy XP
P-VOL in PSUS status
P-VOL in COPY(RS-R)
status
Group)" on page 79 for instructions).
If you are using Command View XP, proceed with
- step 9 for each disk array that will function as a Continuous Access XP MCU. After you
Can volumes be
used as
Continuous
Access XP P-VOL?
Yes
Yes
No
step
Can volumes be Can volumes be
used as used as
Continuous Continuous
Access XP S-VOL? Access XP
Asynchronous
P-VOL?
Yes Yes
Yes Yes
No No
Continuous Access XP user guide for the XP12000/XP10000
"Adding consistency
9. If you are using XP Remote Web
Can volumes be
used as
Continuous
Access XP
Asynchronous
S-VOL?
Yes
Yes
No
37