Pair Settings Parameter List (Pairsplit-S); Pairsplit-S Pane - HP xp12000 User Manual

NOTE: When an asynchronous pair is forcibly deleted, the Continuous Access XP delete range option
must be Group. Therefore, more than one pair cannot be forcibly deleted.
1. Connect to the MCU or RCU of the pairs to be deleted, and start Continuous Access XP. If you plan to
use the Continuous Access XP Async C/T delete range option, connect to the RCU.
2. From the CU Number/Port Number tree on the Continuous Access XP main pane, click the number of
the correct CU image.
3. From the Volume list, click the Continuous Access XP volume pairs. Select either Continuous Access XP
Sync or Async pairs, but not both. If you plan to use the Continuous Access XP Async C/T or Group
delete range option, select only one Continuous Access XP Async pair in the group.
4. Right-click, and click Pairsplit-S. The Pairsplit-S pane appears.
5. Click the pairsplit-S options for selected pairs, and click Set to close the Pairsplit-S pane and set
parameters. The list changes to the Pair Settings Parameter list (Pairsplit-S). Repeat this step as needed
to set pairsplit-S options for pairs.
NOTE:
deleting
6. To execute the pairsplit-S requests quickly, select the Use Time-Saving Mode check box above the Pair
Settings Parameter list (Pairsplit-S).
7. Click Apply on the Continuous Access XP main pane to delete the specified pairs.
8. When deleting Continuous Access XP Asynchronous pairs, verify that the pairsplit-S request completed
successfully by checking the detailed Continuous Access XP pair status information on the Pairdisplay
pane (should be SMPL, not Deleting or Suspended).
When deleting Continuous Access XP Sync pairs, verify that the pairsplit-S request completed
successfully by checking the pair status on the Pair Operation tab (SMPL status).
9. To restart a pair deleted from the RCU, delete the pair from the MCU, and use the Paircreate command
with the appropriate Continuous Access XP initial copy option (Entire or No Copy) to restart the pair.
CAUTION: If a timeout error occurs when the Use Time-Saving Mode option is selected, access the
Continuous Access XP main pane, and confirm the volumes on which the pairsplit-S operation could not be
performed. Deselect the Use Time-Saving Mode option for failed volumes, and retry the pairsplit-S
operation.
When the Pairsplit-S pane closes, the list changes to the Pair Settings Parameter list (Pairsplit-S).
Figure 53

Pair Settings Parameter list (Pairsplit-S)

• Port, Group, and LUN of the selected LU number.
• S/N and SSID of the RCU (MCU if connected to the RCU).
• Mode: Yes (delete forcibly) or No (delete normally).
• Range: Range for deleting the asynchronous pair: Group, LU, or C/T.
104 Continuous Access XP for the XP12000/XP10000
After being set, options can be modified and canceled (see
LUs" on page 90).
"Modifying parameters and