This overview of Continuous Access XP operations describes:
•
"Components" on page 14
• "Remote copy
• "Continuous Access XP Asynchronous recordset
• "Continuous Access XP Asynchronous consistency group
• "Continuous Access XP volume pair
Components
Continuous Access XP operations involve the XP12000/XP10000 at a primary and secondary (remote)
site, physical communications paths between these disk arrays, and Command View XP or XP Remote
Web Console. Continuous Access XP copies online data at the primary site to volumes at the secondary
site via dedicated Fibre Channel remote copy connections.
Host failover software is required for effective disaster recovery with Continuous Access XP.
Figure 1
shows Continuous Access XP components and the following functions:
•
"XP12000/XP10000" on page 14
• "Main and remote control units (MCUs and
• "Volume pairs (P-VOLs and
• "Continuous Access XP Asynchronous consistency
• "Remote copy
• "Initiator ports and RCU target
• "Remote control ports (RCPs) and local control ports
• "Command View XP management station or XP Remote Web
• "Host failover
u
Figure 1
Continuous Access XP components for Fibre Channel connections
XP12000/XP10000
Continuous Access XP operations involve primary (main) disk arrays and secondary (remote) disk arrays
(MCUs and RCUs). This document describes Continuous Access XP operations in which the main disk array
is an XP12000/XP10000 and the remote disk array is an XP12000/XP10000. MCUs contain
Continuous Access XP primary volumes (P-VOLs), which contain original data and are online to the hosts.
RCUs contain Continuous Access XP secondary volumes (S-VOLs), which are synchronous or asynchronous
14
Continuous Access XP for the XP12000/XP10000
operations" on page 19
status" on page 25
S-VOLs)" on page 16
connections" on page 17
ports" on page 17
software" on page 18
operations" on page 21
operations" on page 23
RCUs)" on page 15
groups" on page 16
(LCPs)" on page 18
Console" on page 18