Know Your Product; Setup & Preparation; Assembling The Saw - Ozito CMS-210 Instruction Manual

KNOW YOUR PRODUCT

MITRE SAW
1 Dust bag
2 Cutting head
3 Blade
4 Rear fence
5 Side support bars
6 Operating handle
7 Carbon brush cap
8 Retractable safety guard
9 Rotating mitre table
10 Table insert (kerf plate)
1
2
3
4
5
11
12
13
14
15
16
ACCESSORIES
19 Hex key
ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
11 On/Off switch
12 Carry handle
13 Spindle lock button
14 Head locking pin
15 Mitre table lock knob
16 Side support bar lock knob
17 Bevel adjustment lock knob
18 Rear support bar
6
7
8
9
10
17
18
19
SETUP & PREPARATION

1. ASSEMBLING THE SAW

WARNING! ENSURE THE SAW IS SWITCHED OFF AND
DISCONNECTED FROM THE POWER SUPPLY BEFORE
PERFORMING ANY OF THE FOLLOWING ASSEMBLY.
Release Cutting Head From Transport Position
The mitre saw is shipped with the cutting head locked down and will
need to be released before operation.
1 Press the cutting
head down gently.
2 Pull the head locking pin out
and the cutting head will now
be free to move.
Fitting the Dust Bag
1 Squeeze the clamp
at the end of the
dust bag.
2 Slide the end of the dust bag
over the dust extraction port
and release the clamp.