Know Your Product; Setup & Preparation; Battery And Charger - Ozito PXC PXTBSS-036 Instruction Manual

KNOW YOUR PRODUCT

CORDLESS TABLE SAW
1. Table
2. Extension Table
3. Blade Guard
4. Rip Fence
5. Rip Fence Lock Lever
6. Push Stick Storage
7. Push Stick
8. Bevel Scale
9. Bevel Lock Lever
1 2
11 10
210
(8¼")
17
16
15
BATTERY & CHARGER
This tool is compatible with all batteries & chargers from the Ozito PXC range.
For optimal performance, we recommend the use of 3.0Ah batteries or
higher to operate this PXC Table Saw
ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
10. Height Adjustment Wheel
11. On/Off Switch
12. Riving Knife
13. Spanner Storage
14. Dust Port Adaptor
15. Mitre Guide Storage
16. Battery Seating
17. Extension Table Lock Lever
3 4
9 8
40
TUNGSTEN
MM
CARBIDE
TEETH
TOOTH
HW, t=40 EN 847-1
WARNING!
Do not use tungsten carbide tipped blades for
masonry or metal cutting applications.
THIS SIDE OUT
Max. Speed 6,000/min
Bore: 30mm
Thickness: 1.8mm
.
SETUP & PREPARATION
1. ASSEMBLY
WARNING!
OFF AND THE BATTERIES ARE REMOVED BEFORE
PERFORMING ANY OF THE FOLLOWING TASKS.
Installing The Dust Port Adaptor
A 35mm vacuum hose and vacuum can be attached to the extraction port on
the rear for dust extraction during use.
1. Undo the Phillips head screw on the back
of the unit.
2. Push the dust extraction adaptor onto the
port.
5
3. Replace the screw to lock the adaptor in
place.
6
4. Connect a suitable vacuum or dust extraction system to the dust
extraction adaptor for use with the table saw.
7
Installing The Riving Knife & Blade Guard
1. Unlock the table insert by using
a spanner to turn the insert lock.
Then lift and remove the table
12
insert.
2. Raise the blade to its highest position by
13
turning the adjustment wheel clockwise.
14
Note: Ensure the bevel angle is set to 0°.
3. Use the 10mm spanner to loosen the
riving knife bolt.
4. Insert the riving knife behind
the plate, leaving a 3-8mm gap
between the riving knife and
blade teeth.
5. Re-tighten the riving knife bolt.
6. Replace the table insert and use the
spanner to lock it in place.
ENSURE THE TOOL IS SWITCHED
cm
3 - 8mm
cm