Advertisement
KNOW YOUR PRODUCT
MITRE SAW
1. Material Support Bar
2. Material Clamp
3. Rear Fence
4. Retractable Safety Guard
5. Mitre Lock Knob
6. Rotating Mitre Table
12. Hex Keys, 5 & 6mm
ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
7. Head Locking Pin
8. Release Lever
9. On/Off Switch
10. Carbon Brush Cap
11. Operating Handle
13. Dust Bag
SETUP & PREPARATION
1. ASSEMBLY
WARNING!
ENSURE THE SAW IS SWITCHED OFF AND
DISCONNECTED FROM THE POWER SUPPLY BEFORE
PERFORMING ANY OF THE FOLLOWING ASSEMBLY.
1. Remove foam packaging materials and using the carry handle,
carefully lift the mitre saw from its box and place it on a level
work surface.
2. Release cutting head from
its transport position. While
holding the head of the saw
down release the lock down
knob.
Fitting the Dust Bag
1 Squeeze the clamp
at the end of the
dust bag.
2 Slide the end of the dust bag
over the dust extraction port
and release the clamp.
Material Support Bar
1. Insert the material support
bars into the 2 holes on either
side of the base.
Note:
Ensure they are fully
inserted.
Material Clamp
1. Can be mounted to the
fence, either the left or right
hand side.
2. Secure in place with the 5mm
hex key.
Advertisement
