Table of Contents
Advertisement
3
KNOW YOUR PRODUCT
TABLE SAW
1 Sliding Mitre Gauge
2 Blade Guard
3 Rip Fence
4 Rip Fence Lever
5 Push Stick
6 ON/OFF Switch
1
5
6
ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
7 Blade Height Adjustment Handle
8 Bevel Adjustment Dial
9 Bevel Lock
10 Table Insert
11 Rubber Feet
2
3
4
7
8
9
10 11
SETUP & PREPARATION
1. ADJUSTMENTS
For detailed assembly instructions see Assembly
Manual.
WARNING!
ENSURE THE TOOL IS SWITCHED OFF AND
DISCONNECTED FROM THE POWER SUPPLY BEFORE
PERFORMING ANY OF THE FOLLOWING PROCEDURES.
Cutting Depth
The depth should be adjusted so that no more than one tooth is
protruding through the timber. This helps to minimise splintering.
1 To lower the blade for
a smaller depth of cut,
rotate the blade height
adjustment handle anti-
clockwise.
2 To raise the blade for
a larger depth of cut,
rotate the blade height
adjustment handle
clockwise.
WARNING!
THIS TOOL IS NOT INTENDED FOR
CHANNEL OR TRENCH CUTS.
Bevel Angle
1 Loosen the bevel lock by
rotating anti-clockwise.
2 Rotate the bevel
adjustment dial in to the
desired angle using the
bevel scale.
3 Secure the bevel angle
by rotating the bevel lock
clockwise.
Advertisement
Table of Contents
