Table of Contents
Advertisement
KNOW YOUR PRODUCT
SLIDING MITRE SAW (SCMC-1621)
1. Retractable Safety Guard
2. Material Support Bar
3. Material Clamp
4. Fence
5. Mitre Table
11. Carry Handle
12. Slide Lock
13. Stabilising Bar
14. Bevel Lock
15. Bevel Release
ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
6. Mitre Table Lock
7. Bevel Angle Pointer
8. Lock Down Pin
9. Spindle Lock Button
10. Trigger
16. Laser Guide
17. Additional Support Feet
18. Table Insert
19. Release Lever
SETUP & PREPARATION
1. ASSEMBLY
WARNING!:
ENSURE THE TOOL IS SWITCHED
OFF AND DISCONNECTED FROM THE POWER
SUPPLY BEFORE PERFORMING ANY OF THE
FOLLOWING PROCEDURES.
Unpacking
1. Remove foam packaging materials and using the carry handle,
carefully lift the mitre saw from its box and place it on a level
work surface.
2. Release cutting head from its transport position. While holding
the head of the saw down release the lock down pin.
HOLD
DOWN
Dust Bag
1. Squeeze the clamp at the
end of the dust bag, place
over the dust extraction
port.
Material Clamp
Material clamp will assist
securing timber when making
cuts.
Note:
The clamp can be
mounted on either the left or
right.
Material Support Bars
1. Insert each bar into the
two holes located on
both sides of the base.
2. Tighten screw when in
place.
TIGHTEN
Advertisement
Table of Contents
