Table of Contents
Advertisement
KNOW YOUR PRODUCT
CORDLESS SLIDING MITRE SAW
1.
Battery Seating
2.
Laser On/Off Switch
3.
Lock-Off Lever
4.
Spindle Lock Button
5.
Lock Down Pin
6.
Material Clamp
7.
Fence
8.
Table Insert
9.
Table Lock
10. Table Handle
11. Mitre Angle Pointer
12. Mitre Table
13. Worklight & Laser
14. On/Off Trigger
15. Worklight On/Off Switch
13
12
11
10
16. Combination Key Storage
17. Slide Lock
18. Dust Bag
19. Slide Bar
20. Carry Handle
21. Cutting Handle
22. Saw Blade
16
17
18
19
28
27
26
BATTERY & CHARGER
This tool is compatible with all batteries & chargers from the Ozito PXC range.
For optimal performance, we recommend the use of a 3.0Ah batteries or higher to
operate this PXC Mitre Saw.
ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
1
2
15
OFF
OFF
3
14
4
5
6
7
8
9
23. Trenching Depth Screw
24. Retractable Blade Guard
25. Mounting Point
26. Extension Table Handle
27. Material Stop
28. Bevel lock
20
21
22
23
24
25
SETUP & PREPARATION
1. ASSEMBLY
WARNING!
ENSURE THE TOOL IS TURNED OFF
AND DISCONNECTED FROM THE POWER SUPPLY
BEFORE PERFORMING ANY OF THE FOLLOWING
OPERATIONS.
Note: The combination key is located inside the slot on the slide bar
at the back of the unit, and can be used for assembly. Make sure the
correct extension table is used for left & right sides respectively. Ensure
the extension tables are installed correctly, and always use the extension
tables during operation.
1. Remove the screw from the bar of the extension table.
2. Press and hold the lever located
inside the extension table handle
and slide the bars into the slots on
the unit. The notched bar should be
inserted through the bracket on the
underside of the unit.
3. Replace and tighten the screw.
4. Repeat steps 1, 2 & 3 for the other extension table.
5. Align the table handle with the bar on the
mitre table and screw it into place.
6. Press the end cap into the table handle.
7. Remove the screws on the top of the unit.
8. Align the holes in the carry handle
with the screw holes and then
replace the screws to attach the
carry handle.
9. Squeeze the clamp at the end of the
dust bag and place it over the dust
extraction port.
Note: The dust extraction port can block easily
with dust and requires to be periodically cleaned.
For more efficient operation, empty the
dust bag when it is no more than half full.
This allows better air flow through the bag.
Dust bags will not collect all the saw dust
generated by the mitre saw. For best results
a dust extractor should be used in place of
the dust bag.
9. Hold down the cutting head and pull the lock down pin to release the
cutting head from its transport position.
HOLD
DOWN
Advertisement
Table of Contents
