Table of Contents
Advertisement
KNOW YOUR PRODUCT
COMPOUND MITRE SAW
1. Carry Handle
2. Retractable Blade Guard
3. Safety Release Lever
4. On/Off Trigger
5. Cutting Handle
6. Motor
7. Lock Down Pin
1
2
3
13
12
ONLINE MANUAL
Scan this QR Code with your mobile
device to take you to the online manual.
8. Bevel lock
9. Mounting Point
10. Fence
11. Mitre Table
12. Mitre Table Lock
13. Material Clamp
4
5
11
10
9
SETUP & PREPARATION
1. ASSEMBLY
WARNING!
DISCONNECTED FROM THE POWER SUPPLY BEFORE
PERFORMING ANY OF THE FOLLOWING OPERATIONS.
Unpacking
1. Remove foam packaging materials and using the carry handle,
carefully lift the mitre saw from its box and place it on a level
work surface.
2. Release cutting
head from
its transport
position. While
holding the
head of the saw
down release
the lock down
pin.
Dust Bag
1. Squeeze the clamp at the end of the
dust bag, place over the dust extraction
port.
6
Note: The dust extraction port can block
easily with dust and requires to
be periodically cleaned. For more
efficient operation, empty the dust
7
bag when it is no more than half
full. This allows better air flow
8
through the bag. Dust bags will not
collect all the saw dust generated
by the mitre saw. For best results a dust extractor should be
used in place of the dust bag.
Note: You can also attach an Ozito Vaccum hose to the extraction
port to collect the dust.
Material Clamp
Material clamp will assist
securing timber when making
cuts.
The clamp can be mounted on
either the left or right.
When performing a bevel or compound
cut, the material clamp should be
positioned on the right hand side of the
fence.
ENSURE THE TOOL IS TURNED OFF AND
HOLD
DOWN
Advertisement
Table of Contents
