Table of Contents
Advertisement
KNOW YOUR PRODUCT
CORDLESS CIRCULAR SAW
1 Battery Seating
2 Rear Handle
3 Dust Port
4 On/Off Trigger
5 Lock-Off Lever
6 Hex Key Holder
7 Front Handle
8 Worklight
1
2
3
4
5
10
11
BATTERY & CHARGER
This tool is compatible with all battery and chargers from the Ozito
Power X Change Range.
For optimal performance, we recommend the use of a 3.0Ah battery or
higher to operate this Power X Change Circular Saw.
ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to the
online manual.
9 Rip Fence Locking Knob
10 Depth Locking Lever
11 Blade Guard Lever
12 Lower Blade Guard
13 Blade
14 Upper Blade Guard
15 Bevel Locking Knob
16 Cutting Guide Notch
6
7
8
9
12
13
14
15
16
SETUP & PREPARATION
1. FITTING THE BATTERY & GUIDE
Inserting & Removing the Battery
1 Slide the battery into the seating
at the back of the saw until it
clicks into place.
2 To remove, press and
hold the battery release
tab and then slide out.
Attaching the Rip Fence
The rip fence allows you to perform straight cuts with ease.
1 Insert the rip fence through the
rip fence slots in the front of the
baseplate.
2 Once the desired
width is set, tighten
the locking knob to
secure in place.
3 To remove, loosen the locking
knob and then slide the rip fence
out.
a
b
Advertisement
Table of Contents
