Grandstream Networks GVC3200 Administration Manual page 51

It is used to configure the vendor class ID header in the DHCP request. The default
Vendor Class ID
setting is "Grandstream GVC3200" for GVC3200 and "Grandstream GVC3202" for
(Option 60)
GVC3202.
DHCP Option 120
Enables DHCP Option 120 from local server to override the SIP Server on the
Override SIP
device when DHCP is used. The default setting is "Yes".
Server
It is used to configure the device's static IP address if the static IP is used.
IP Address
It is used to configure the network's subnet mask if the static IP is used.
Subnet Mask
It is used to configure the network's gateway address if the static IP is used.
Default Router
DNS Server 1 It is used to configure the primary DNS IP address if the static IP is used.
DNS Server 2 It is used to configure the secondary DNS IP address if the static IP is used.
PPPoE Account It is used to configure the PPPoE account ID if the PPPoE is used.
PPPoE Password It is used to configure the PPPoE password if the PPPoE is used.
802.1x Mode
It is used to enable and select the 802.1x mode for the device. The supported
802.1x modes are:

802.1x Mode


The default setting is "Close".
It is used to fill in the identity information for the selected 802.1x mode. This setting
802.1x Identity
will be displayed only if 802.1x mode is enabled.
It is used to enter the secret for the 802.1x mode. This setting will be displayed only
802.1x Secret
if the 802.1x mode is enabled.
It is used to enter the private key password for the 802.1x mode. This setting will be
Private Key
displayed only if the 802.1x mode is enabled.
It is used to upload the CA Certificate file to the device. This setting will be displayed
CA Certificate
only if the 802.1x mode is enabled.
It is used to load the Client Certificate file to the device. This setting will be displayed
Client Certificate
only if the 802.1x TLS mode is enabled.
QoS
It is used to enable the LLDP (Link Layer Discovery Protocol) feature on the device.
If it is set to "Yes", the device will broadcast LLDP PDU to advertise its identity and
Enable LLDP
capabilities and receive same from a physical adjacent layer 2 peer. The default
setting is "Yes".
Firmware Version 1.0.1.48
www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
EAP-MD5
EAP-TLS
EAP-PEAP
GVC3200/GVC3202 Administration Guide Page 50 of 71