Changing Multi-Function Button Labels; Changing Beep Volume - Kenwood TM-V7A Instruction Manual

CHANGING MULTI-FUNCTION BUTTON LABELS

1
This transceiver shows button labels on the lower portion of
the display. You can also change the default configuration
2
to one of the following types. Select the configuration
3
depending on which functions you use most frequently.
4
Basic State Display Labels
[F] [TONE] [DTSS] [LOW] [OFF] [SHIFT] [REV] [VISUAL]
5
6
Basic State Display Labels
7
[F] [VISUAL] [REV] [LOW]
8
Note:
The labels that appear after pressing [F] (1 s) are identical no matter
9
which configuration you select.
After selecting the F/TONE/DTSS/LOW configuration, press
10
[F], [REV] (1 s) to activate ASC {page 27} and press [F], [REV] to
cancel the function.
11
After selecting the F/VISUAL/REV/LOW configuration, press
[F], [TONE] (1 s) to activate Automatic Tone Frequency ID {page 49}
12
and press any key to cancel the function.
13
1 Press [MNU] to enter Menu mode.
2 Select Menu No. 2 (Front Panel).
14
3 Press [ s s s s s ] , then select Item No. 3.
15
16
CALL CALL
17
18
2
19
4 Press [SET] repeatedly until the desired configuration
20
appears.
21
5 Press [MNU] again to exit Menu mode.
66
Labels after Pressing [F]
or
Labels after Pressing [F]
[OFF] [TONE] [SHIFT] [DTSS]
PWR PWR
VOL SQL
1

CHANGING BEEP VOLUME

The transceiver beeps each time you press a button or a
microphone key. You can change the beep volume or turn
it off.
1 Press [MNU] to enter Menu mode.
2 Select Menu No. 14 (Audio).
CALL CALL
2
3 Press [ s s s s s ] , then select Item No. 1 (Beep Volume).
CALL CALL
2
4 Press [SET] , then select the volume from level 1 (min.)
to 7 (max.) and OFF. The default is level 5.
CALL CALL
2
5 Press [MNU] again to exit Menu mode.
PWR PWR
VOL SQL
PWR PWR
VOL SQL
1
PWR PWR
VOL SQL
1