GE 745 Instruction Manual page 237

CHAPTER 6: ACTUAL VALUES
745 TRANSFORMER PROTECTION SYSTEM – INSTRUCTION MANUAL
PRESS [ENTER] TO
ADD AS DEFAULT
PRESS [ENTER] TO
BEGIN TEXT EDIT
PRESS [ENTER] TO
REMOVE MESSAGE
PRESSED KEY
IS INVALID HERE
RESETTING LATCHED
CONDITIONS
SETPOINT ACCESS
DENIED (PASSCODE)
SETPOINT ACCESS
DENIED (SWITCH)
SETPOINT ACCESS
IS NOW ALLOWED
SETPOINT ACCESS
IS NOW RESTRICTED
TARGET AND FLASH MESSAGES
This flash message is displayed for 5 seconds in
response to pressing the decimal key followed by
ENTER while displaying any setpoint or actual value
message except the S1 745 SETUP
MESSAGES SELECTED DEFAULTS

ENTER again while this message is displayed adds the
setpoint or actual value message to the default list.
This flash message is displayed in response to pressing
the VALUE keys while on a setpoint message with a
text entry value. The ENTER key must first be pressed
to begin editing.
This flash message is displayed for 5 seconds in
response to pressing the decimal key followed by
ENTER while displaying one of the selected default
messages in the S1 745 SETUP
menu. Pressing ENTER again
SELECTED DEFAULTS

while this message is displayed removes the default
message.
This flash message is displayed in response to any
pressed key that has no meaning in the current
context.
This flash message is displayed in response to pressing
RESET when the relay is in local mode. All active
targets for which the activating condition is no longer
present will be cleared.
This flash message is displayed in response to pressing
ENTER while on any setpoint message. Setpoint access
is restricted because the programmed passcode has
not been entered to allow access.
This flash message is displayed in response to pressing
ENTER while on any setpoint message. Setpoint access
is restricted because the setpoint access terminals
have not been connected.
This flash message is displayed in response to entering
the programmed passcode at the
PASSCODE ALLOW SETPOINT WRITE ACCESS

setpoint. The command to allow write access to
setpoints has been successfully executed and
setpoints can be changed and entered.
This flash message is displayed in response to
correctly entering the programmed passcode at
745 SETUP PASSCODE
 
. The command to restrict access to setpoints
ACCESS
has been successfully executed and setpoints cannot
be changed.
DEFAULT

setpoint. Pressing
DEFAULT MESSAGES

S1 745 SETUP

S1
ALLOW SETPOINT WRITE
6–29