Electrical Requirements; Feature Specifications - Xerox Versant 80 Press Installation Manual

Versant 80 Press

Electrical Requirements

Electrical
Press
Additional electrical required for print server,
feeding / finishing devices.
(Note: HCF, BR Finisher and BR Booklet
Finisher plug directly into press and require
no additional receptacle.)
For detailed information refer to
Power Consumption
Voltage
Power Consumption
Standby Mode
Warm up Time from Power off

Feature Specifications

Print Xerox Versant ® 80 Press
* Using Centerline Paper
First Print Out Time 
(FPOT)



Resolution
 2400 x 2400 x 1 dpi** (Print Engine Addressability)
 1200x1200 dpi RIP resolution
 8 bits per pixel bit depth
**dpi = dots per inch
Customer Expectation & Installation Guide
Xerox Versant ® 80 Press
North America Receptacle:
208–240 VAC, 50/60 Hz,
NEMA 6-20R
Europe: receptacle that mates to the PCE Shark 023-6 plug (shown below)
220 – 240 VAC, 50Hz
Nema 5-15R or 5-20R
Electrical Requirements.
Xerox Versant ® 80 Press
XC – 208 - 240 V
XE – 220 - 40 V
XC – 208 – 3.66 kW or less
240 – 4.224 kW or less
XE – 220 – 4.4 kW or less
240 – 4.8 kW or less
1,400 watts
≤ 5 minutes
In "Ready Mode" the FPOT is on average less than 8
sec. for color and less than 10 sec. for B/W.
At initial power on copy/print, the system requires
between 30 and 45 seconds to produce the first print.
Switching from a Color Mode job to a B/W job or the
reverse requires on average between 30-60 seconds.
60 seconds is always needed after a paper jam to
ensure the system is recovered from possible
contamination, and ensure that the image quality is
optimized.
FPOT is measured from the time the Printer starts to the time the trail
edge of the sheet exits the Offset Catch Tray.
Note: If the system is equipped with various types of finishing devices,
the FPOT time will vary depending on the length of the paper path
needed to transport that paper.
Halftones Screens supported:
300 dot, 200 line, 175 dot 150 dot, 200 dot, and stochastic
7