General Remarks - Wiener PL512 Technical Manual

The only purpose of this manual is a description of the product. It must not be interpreted as
a declaration of conformity for this product including the product and software.
e e
W-I -N -R revises this product and manual without notice. Differences of the description in
manual and product are possible.
e e
W-I -N -R excludes completely any liability for loss of profits, loss of business, loss of use
or data, interrupt of business, or for indirect, special incidental, or consequential damages of
any kind, even if W-I
from any defect or error in this manual or product.
Any use of the product which may influence health of human beings requires the express
written permission of W-I
Products mentioned in this manual are mentioned for identification purposes only. Product
names appearing in this manual may or may not be registered trademarks or copyrights of
their respective companies.
No part of this product, including the product and the software may be reproduced,
transmitted, transcribed, stored in a retrieval system, or translated into any language in any
form by any means with the express written permission of W-I
In the context of this user manual, the control cabinet must fulfill the requirements on fire-
protective enclosures according to EN 60950 / IEC 60950 / UL 60950.
All devices are intended for operation in control cabinets or in closed areas. The LAN
connection and all wire connections between the different system parts must be done via
shielded cable with conductive connector shells, which are fixed with screws.
Furthermore, an additional fire-protective enclosure is required which must not affect proper
air circulation.
The Power supplies are equipped with a "World"- mains input (rated voltage range: 100-240
VAC, frequency: 50-60 Hz, rated current: 16 A). Before connecting to the mains please
double-check correspondence.
The mains input connection at the power supply side is described in chapter 2.1 (AC Mains
Connection) at page 2.
After connecting the
permanently. Filter and storage capacitors of the power factor correction module are charged
with about 400VDC. Any DC-On-Signal as well as a power switch at control board (if any
installed) operates as a low voltage DC on/off switch only and not as a mains breaker.
Therefore it becomes dangerous if the box cover is open. In this case a lot of
components on high voltage potential get touchable!
Before starting any kind of work inside the power box remove
the unit from mains and wait a couple of minutes with your
activities! Discharge the primary DC filter-capacitors by use of
a well insulated 22 ohm 10W resistor.
We recommend in case of any malfunction to send the power
box to Wiener or to one of our representative for service
2. April 2014

General Remarks

e e
-N -R has been advises of the possibility of such damages arising
e e
-N -R.
Control Cabinet
Mains Voltage and Connection
Safety
Power box to the mains, the mains input module is powered
e e
-N -R.
i *00679.A4