Led Description; Function Of The Switches - Wiener PL512 Technical Manual

2.9.1 LED Description

Power LED (green, 5mm)
●
Status LED (green, 3mm)
●
Overheat (yellow)
●
SYS FAIL (red)
●

2.9.2 Function of the Switches

After the PL512/PL506 has been switched on by pushing the "Power" switch up, the main operation
modes can be selected by pushing the "Mode Select" switch up or down.
Many main operating modes do have one or more submenus, which can be accessed by a special
procedure.
You will use the following switches of the PL512/PL506:
Symbol Description
P▲ Push "Power" switch up (ON)
P▼ Push "Power" switch down
(OFF)
M▲ Push "Mode Select" switch up
M▼ Push "Mode Select" switch
down
28. May 2013
Lighting if the PL512/PL506 is operating. Channels may be
on.
Lighting if the main processor is working properly .
Lighting if the operating temperature inside of the
power supply is too high.
Processor malfunction.
Remarks
Main power supply is off:
Switch the power supply on. All power
channels are off.
Display shows a switched off channel:
Switch this channel on.
Submenu:
OK button. Used to enter the selected
submenu, request to change a value, accept
the changes.
Display shows a switched off channel:
Switch the main power supply and all
channels off.
Display shows a switched on channel:
Switch this channel off.
Submenu:
CANCEL button. Used to leave a submenu,
discard the changes.
Main operating mode:
Select the next operating mode.
Submenu:
Change the selected item to the next possible
state.
Main operating mode:
Select the previous operating mode.
Submenu:
Change the selected item to the previous
possible state.
7 *00679.A4