Power Output And Sense Connections Pl506; Pl512/Pl506 Control And Setup Via Usb; Figure 2.4: Pl506 Rear Side (Power Output Connections); Figure 2.5: Pl512 Rear Side (Power Output Connections) - Wiener PL512 Technical Manual

The sense lines are routed to three DSUB connectors (four channels each).
SUB9 male
Table 7: Sense Connector Pin Assignment

2.11 Power Output and Sense Connections PL506

Figure 2.4: PL506 Rear Side (Power Output Connections)

Figure 2.5: PL506 Rear Side (Power Output Connections)
The low voltage DC output at the rear side of the power supply is provided by 6 mm or 8mm sockets
. The channels are arranged from left to right starting with U0. Positive output is up and negative
output is down.
The sense lines are routed to three DSUB connectors (2 channels each).
DSUB9 male
Table 8: Sense Connector Pin Assignment

3 PL512/PL506 Control and Setup via USB

The PL512/PL506 can be controlled with the MUSEcontrol software. Without the Display option
this is the only way to change the network (TCP/IP) settings.
28. May 2013
Pin Left Connector (U0..U3)
1 U0 Sense +
6 U0 Sense -
2 U1 Sense +
7 U1 Sense -
3 U2 Sense +
8 U2 Sense -
4 U3 Sense +
9 U3 Sense -
5 not connected
Pin Left Connector (U0..U3)
1 U0 Sense +
6 U0 Sense -
2 U1 Sense +
7 U1 Sense -
3 not connected
8 not connected
4 not connected
9 not connected
5 not connected
Middle Connector (U4..U7)
U4 Sense +
U4 Sense -
U5 Sense +
U5 Sense -
U6 Sense +
U6 Sense -
U7 Sense +
U7 Sense -
not connected
Middle Connector (U4..U7)
U2Sense +
U2Sense -
U3Sense +
U3Sense -
not connected
not connected
not connected
not connected
not connected
10
Right Connector (U8..U11)
U8 Sense +
U8 Sense -
U9 Sense +
U9 Sense -
U10 Sense +
U10 Sense -
U11 Sense +
U11 Sense -
not connected
Right Connector (U8..U11)
U4 Sense +
U4 Sense -
U5 Sense +
U5 Sense -
not connected
not connected
not connected
not connected
not connected
*00679.A4