Custom Audio Electronics KUBE II Scanner User Manual page 51

UPDATE VIA USB INTERFACE
ATTENTION:
Only during the irmware update, the connection be-
tween PC and device must be direct, without the use
of wireless HUB.
Only during the irmware update, do not connect or
disconnect other USB devices.
NOTE: For communication via USB you must install on
PC the device driver available in the download area of
the web site www.custom.biz.
Proceed as follows:
1. Write down the product code (14 digits) printed on the
product label (see par. 2.3).
2. Go to the web site www.custom.biz and download the
appropriate irmware release from the DOWNLOAD
area.
3. Print the SETUP report (see chapter 5).
4. Switch OFF the device.
5. Connect the device to the PC using a USB cable (see
paragraph 3.1).
6. Switch ON the device.
7. Launch the software UPGCEPRN.
8. Select the update ile .PSW location:
9. Select item USB and then select the USB device among
those proposed (eg. KUBEIISCANNER):
Custom KUBEIISCANNER
Custom KUBEIISCANNER
C:\KUBEIISCANNER.PSW
10. After a few minutes a message on the screen warns
that the update is completed.
11. Print a new SETUP report to verify the new irmware
release (see chapter 5).
51