Custom Audio Electronics KUBE II Scanner User Manual page 38

TOTAL CUT
PAPEREND BUFFER
CLEAR
POWERFAIL
WAKEUP MODE
PRINT DENSITY
38
Sets the behavior of the cutter when the total cut command 0x1B 0x69 ( i) is sent:
Disabled = The total cut command 0x1B 0x69 ( i) will be ignored and the device executes
a partial cut
D
Enabled = The total cut command 0x1B 0x69 ( i) will be executed.
Cleaning mode of the data in receive buffer, if the printing is stopped due to lack of paper:
Disabled = The data remain in the receive buffer. When the paper runs out, the device
keeps the remaining data in the receive buffer and prints the remaining
portion of the ticket after that the new paper is loaded.
D
Enabled = When the paper runs out, all data in the receive buffer are deleted.
This parameter set the printer state (ON or OFF) that will be automatically restored after
a power fail:
LAST PWR State
D
= the printer returns in the previous state (ON or OFF) before the
power fail.
Always ON = the printer always switches on automatically, after a power fail.
D
Always OFF = the printer switches on only by pressing the ON/OFF key after a
power fail.
Adjusting the printing density:
-50% -12% +25%
-37% 0 D +37%
-25% +12% +50%