Specifications; Ec Declaration Of Conformity - Makita UT1305 Instruction Manual

ENGLISH (Original instructions)
1-1. Lock button
1-2. Switch trigger
2-1. Indicator lamp
3-1. Hex nut
3-2. Shaft
3-3. Shaft holder

SPECIFICATIONS

No load speed (min
Mixing blade diameter
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for mixing wall materials, etc.
(except flammable materials)
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
Explanation of general view
4-1. Wrench 19
4-2. Notch
4-3. Wrench 19
6-1. Mixing blade
6-2. Shaft
6-3. Hex bolt
Model
-1
)
Overall length
Net weight
Safety class
) : 82 dB(A)
pA
) : 93 dB(A)
WA
value (tri-axial vector
2
) : 2.5 m/s or less
h
2
ENE056-1
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
ENF002-2
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
ENG905-1
is running idle in addition to the trigger time).
For European countries only

EC Declaration of Conformity

We Makita
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
Power Mixer
ENG900-1
Model No./ Type: UT1305
are of series production and
sum)
Conforms to the following European Directives:
2006/42/EC
And are manufactured in accordance with the following
standards or standardised documents:
EN60745
ENG901-1
The technical documentation is kept by our authorised
representative in Europe who is:
Makita International Europe Ltd.
Michigan Drive, Tongwell,
Milton Keynes, Bucks MK15 8JD, England
3
7-1. Filter
7-2. Cover
7-3. Screwdriver
8-1. Limit mark
9-1. Screwdriver
9-2. Brush holder cap
UT1305
1,300
165 mm
942 mm
3.3 kg
/II
Corporation as the
ENH101-15
responsible