Download Print this page

Advertisement

Power Mixer
MODEL UT2204
I N S T R U C T I O N
WARNING:
For your personal safety, READ and UNDERSTAND before using.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
DOUBLE
INSULATION
M A N U A L
007128

Advertisement

   Summary of Contents for Makita UT2204

  • Page 1

    Power Mixer MODEL UT2204 007128 DOUBLE INSULATION I N S T R U C T I O N M A N U A L WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

  • Page 2: Specifications

    (except flammable materials) Responsible manufacturer: Power supply Makita Corporation Anjo Aichi Japan The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They...

  • Page 3: General Safety Rules

    GENERAL SAFETY RULES GEA001-3 WARNING: Read all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. The term “power tool” in all of the warnings listed below refers to your mains-operated (corded) power tool or battery- operated (cordless) power tool.

  • Page 4: Specific Safety Rules

    19. Store idle power tools out of the reach of chil- the manner intended for the particular type of dren and do not allow persons unfamiliar with power tool, taking into account the working con- the power tool or these instructions to operate ditions and the work to be performed.

  • Page 5: Functional Description

    FUNCTIONAL CAUTION: DESCRIPTION • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Switch action 007096 CAUTION: • Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the “OFF”...

  • Page 6

    Hold the notch in the shaft holder with wrench 19 so that it cannot revolve. 007093 With the notch held so, tighten the hex nut with another wrench 19 in the direc- tion of arrow 1. Wrench 19 2. Notch 3.

  • Page 7

    When installing the mixing blades at two different positions (which is applicable 007103 only to the mixing blades allowed to do so), mount and secure the two mixing blades on the flat part of the shaft with the hex bolts so that the same surface of blades faces each other as shown in the figure.

  • Page 8

    CAUTION: • These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.

  • Page 9

    Memo...

  • Page 10

    Memo...

  • Page 11

    Memo...

  • Page 12

    Makita Corporation Anjo, Aichi, Japan 884659-225...

This manual also for:

Ut1305

Comments to this Manuals

Symbols: 0
Latest comments: