Specifications - Makita UT001G Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Model:
No load speed
Maximum mixing blade diameter
Overall length
(without shaft and mixing blade)
Rated voltage
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications and battery cartridge may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combinations, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Symbols
The followings show the symbols which may be used
for the equipment. Be sure that you understand their
meaning before use.
Read instruction manual.
Do not use the tool in the rain.
Do not clean the tool with water.
Only for EU countries
Ni-MH
Due to the presence of hazardous com-
Li-ion
ponents in the equipment, waste electrical
and electronic equipment, accumulators
and batteries may have a negative impact
on the environment and human health.
Do not dispose of electrical and electronic
appliances or batteries with household waste!
In accordance with the European Directive
on waste electrical and electronic equipment
and on accumulators and batteries and
waste accumulators and batteries, as well as
their adaptation to national law, waste elec-
trical equipment, batteries and accumulators
should be stored separately and delivered
to a separate collection point for municipal
waste, operating in accordance with the
regulations on environmental protection.
This is indicated by the symbol of the crossed-
out wheeled bin placed on the equipment.
High speed mode
Low speed mode
with battery cover S
with battery cover L
UT001G
373 mm
412 mm
D.C. 36 V - 40 V max
5.7 - 7.0 kg
BL4020 / BL4025 / BL4040* / BL4050F* / BL4080F*
* : Recommended battery
DC40RA / DC40RB / DC40RC
Intended use
The tool is intended for mixing wall materials, etc.
(except flammable materials).
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-2-10:
Model UT001G
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Model UT002G
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
NOTE: The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure.
6 ENGLISH
UT002G
-1
0 - 920 min
-1
0 - 500 min
240 mm
363 mm
403 mm
5.8 - 7.2 kg
) : 81 dB (A)
pA
) : 92 dB (A)
WA
) : 81 dB(A)
pA
) : 92 dB (A)
WA