Wireless Configuration For Macintosh Using The Brother Installer Application (Mfc-9320Cw Only); Configuration In Infrastructure Mode; Before Configuring The Wireless Settings - Brother DCP-9010CN Network User's Manual

Wireless configuration for Macintosh
5
using the Brother installer application
(MFC-9320CW only)

Configuration in Infrastructure mode

Before configuring the wireless settings

IMPORTANT
• The following instructions will install your Brother machine in a network environment using the Brother
installer application for Macintosh found on the CD-ROM we have provided with the machine.
• You must know your wireless network settings before you proceed with this installation.
Make sure you take notes on all the current settings such as SSID, authentication and encryption of your
wireless network environment. If you do not know them, contact your network administrator or the
manufacturer of your access point/router.
Check and record the current wireless network settings.
Network name:(SSID, ESSID)
Communication Mode
Infrastructure
1
WPA/WPA2-PSK is a Wi-Fi Protected Access Pre-Shared Key, which lets the Brother wireless machine associate with access points using
TKIP or AES encryption (WPA-Personal). WPA2-PSK (AES), WPA-PSK (TKIP/AES) uses a Pre-Shared Key (PSK) that is 8 or more
characters in length, up to a maximum of 63 characters.
Authentication method
Open system
Shared key
1
WPA/WPA2-PSK
LEAP
EAP-FAST/NONE
EAP-FAST/MS-CHAPv2
EAP-FAST/GTC
Encryption mode
2
WEP
NONE
2
WEP
AES
3
TKIP
CKIP
AES
TKIP
4
Network key
—
42
5
5
5
5