Using The Setup Wizard From The Control Panel - Brother DCP-9010CN Network User's Manual

Configuring your machine for a wireless network (For MFC-9320CW)

Using the Setup Wizard from the control panel

You can configure your Brother machine by using the Setup Wizard function. This is located in the
Network menu on the machine's control panel. See to the steps below for further information.
a
Write down the wireless network settings of your access point or wireless router. If you do not know them,
contact your network administrator or the manufacturer of your access point/router.
Check and record the current wireless network settings.
Network name:(SSID, ESSID)
Communication Mode
Infrastructure
Ad-hoc
1
WPA/WPA2-PSK is a Wi-Fi Protected Access Pre-Shared Key, which lets the Brother wireless machine associate with access points using
TKIP or AES encryption (WPA-Personal). WPA2-PSK (AES), WPA-PSK (TKIP/AES) uses a Pre-Shared Key (PSK) that is 8 or more
characters in length, up to a maximum of 63 characters.
2
The WEP key is for 64-bit encrypted networks or 128-bit encrypted networks and can contain both numbers and letters. If you do not know
this information you should see the documentation provided with your access point or wireless router. This key is a 64-bit or 128-bit value
that must be entered in an ASCII or HEXADECIMAL format.
For example:
64-bit ASCII:
64-bit Hexadecimal:
128-bit ASCII:
128-bit Hexadecimal:
3
This is supported for WPA-PSK only
4
Encryption key, WEP key, Passphrase.
For LEAP and EAP-FAST, record the User Name and Password
Authentication method
Open system
Shared key
1
WPA/WPA2-PSK
LEAP
EAP-FAST/NONE
EAP-FAST/MS-CHAPv2
EAP-FAST/GTC
Open system
Uses 5 text characters e.g. "Hello" (this is case sensitive)
Uses 10 digits of hexadecimal data e.g. "71f2234aba"
Uses 13 text characters e.g.
"Wirelesscomms" (this is case sensitive)
Uses 26 digits of hexadecimal data
e.g."71f2234ab56cd709e5412aa3ba"
Encryption mode
2
WEP
NONE
2
WEP
AES
3
TKIP
CKIP
AES
TKIP
2
WEP
NONE
4
Network key
—
—
34
3
3