Wireless Configuration For Macintosh ® Using The Brother Installer Application; Configuration In Infrastructure Mode; Before Configuring The Wireless Settings; Configure The Wireless Settings - Brother Network MFC-7840W Network User's Manual

Wireless configuration for Macintosh
5
using the Brother installer application
IMPORTANT
• The following instructions will install your Brother machine in a network environment using the Brother
installer application for Macintosh
• You can also setup your Brother machine using the machine's control panel (recommended). You can find
instructions in the supplied Quick Setup Guide or see Configuring your machine for a wireless network
on page 19.
• If you are going to connect your Brother machine to your network, we recommend that you contact your
system administrator prior to installation. You must know your wireless network settings before you
proceed with this installation.

Configuration in Infrastructure mode

Before configuring the wireless settings

IMPORTANT
• If you have previously configured the wireless settings of the machine, you must reset the network LAN
settings before you can configure the wireless settings again. Press Menu, 5, 0 for Factory Reset,
Reset and choose Yes to accept the change. The machine will restart automatically.
• If you are using personal Firewall software, disable it. Once you are sure that you can print, restart your
personal Firewall software.
• You need to temporarily use an Ethernet cable during configuration.

Configure the wireless settings

a
Plug the machine's power cord into the AC power outlet. Turn on the machine's power switch.
b
Turn on your Macintosh
c
Put the supplied CD-ROM into your CD-ROM drive. Double-click the MFL-Pro Suite icon on your
desktop.
®
on the CD-ROM we have provided with the machine.
®
.
®
5
5
5
5
5
56