Alarm Setting - Wansview Pro HD User Manual

4.4.4 Alarm Setting

Access to "Alarm Setting", there are options for Alarm Area and Alarm IO.
Alarm Deployment
IO Detection：Sensor type can choose Always open or Always close. When using IO Check, user should enable IO detection,
Always open means external alarm device is needed, and only with alarm trigger, alarm will be valid. If choose Always close, the
camera will be alarm continuously per 30 second.
Motion Detection: Sensitivity can choose Low/ Middle/ High according to needs.
Audio Detection: Sensitivity can choose Low/ Middle/ High according to needs.
Temperature detection: the temperature range can be set from -100℃ to 100℃
"<"means the temperature below the set value, the camera will send alarm notification.
">"Means the temperature above the set value, the camera will send alarm notification.
Humidity detection: the humidity range can be set from 0% to 100%.
"<"means the humidity below the set value, the camera will send alarm notification.
">"Means the humidity above the set value, the camera will send alarm notification.
Trigger Alone : The alarm will be triggered for any kind of alarm condition.
Trigger Linkage: If set two or more kinds of alarm methods, only met all alarm conditions, the alarm can be triggered.
Alarm Action:
Save Picture to Email: When a alarm is detected, the camera will send two alarm pictures to the email you set. We support Gmail,
hotmail,Yahoo,Gmx etc.
Save Picture to FTP： When a alarm is detected, the camera will send 2 alarm pictures to to the FTP server you set, 3-4 pictures will
be sent if the motion is too frequent.
Save Record to FTP： When an alarm is detected, the camera will send alarm video to the FTP server you set. The video length is
about 15 seconds for each alarm video, for constant recording, the alarm will be upload to FTP every 30seconds.
Save Picture to SD/TF：When a alarm is detected, the camera will send 2 alarm pictures to SD card, 3-4 pictures will be sent if the
motion is too frequent.
Save Record to SD/TF： When an alarm is detected, the camera will send alarm video to the FTP server you set. The video length is
about 15 seconds for each alarm video, for constant recording, the alarm will be upload to FTP every 30seconds.
Trigger IO Output：When an alarm is detected, the external IO output device will be linked then send alarm; it doesn't support
PoE.
Preset Linkage：When an alarm is detected, it will be linked to the camera to Pan/Tilt the camera to the Preset you set.
Speaker Linkage：Link the speaker to send alarm when a alarm is detected.
Support Email/ Skype: service2@wansview.com 29