Onvif Setting; Alarm Setting; External Alarm Input - Wansview NCM620W User Manual

http://www.wansview.com
Notice: Using the third party DDNS, if the http port is not 80, the port number should be
adding to the domain name with colon.
Example: http://mydomain.dyndns.org:81.

3.2.4. ONVIF setting

The camera supports ONVIF protocol, so it can be interconnected with other factory
camera with ONVIF.
Tips: The device supports ONVIF 2.0.1 at present.

3.3. Alarm setting

3.3.1. External Alarm Input

The camera should have external alarm input port for enable this functions. Connect
external alarm detector to the input port, the detector will output switching signal when it
detects any abnormal, input port of the camera will detect the level change, so it will
detect the alarm, therefore the detector should be switching sensor (same as switch)
Figure 15
Figure 16
Figure 17
19