Term
ROOM
Heat transfer fluid
circuit
Heat curve
10
Default settings in the control computer
The first column in the table below shows the parameters that can be adjusted by the User.
The second column shows settings made at the factory, and the third column the settings
made by the installation contractor in connection with installation of the heat pump.
Make sure that the installation contractor enters any settings made during installation that
are particular to your heat pump. This will make it easier for you when you make your own
adjustments.
Setting
ROOM
OPERATION
CURVE
MIN
MAX
CURVE 5
CURVE 0
CURVE -5
HEATSTOP
Explanation
If ROOM shows 20°C the heat curve is not affected. If ROOM
shows higher or lower, this indicates that the heat curve has been
adjusted up or down to change the indoor temperature.
The fluid circuit obtains heat/energy from the refrigerant circuit,
which it then transports to the water tank or heating system. See
the "About your heat pump" section for further information.
The control computer determines the correct temperature of the
water to be distributed to the heating system based on the heat
curve. The indoor temperature is adjusted by changing the gra-
dient of the heating system's CURVE.
Factory setting
20°C
AUTO
40°C
10°C
55°C
0°C
0°C
0°C
17°C
Customer specific settings
EN
45
ENGLISH