Asus SL6000 Setup Instructions page 82

Chapter 7. The Configuration Pages in more detail
•
Destination Port: This section allows you to set the destination port to which this rule should
apply. You can use the drop-down list to select one of the following:
Any: You can select this option if you would not like to specify any specific port.
o
Single: You can specify the exact destination port number.
o
Range: You can specify the destination port range.
o
Service: You can select any of the configured service instead of the destination port.
o
•
Protocol: Select the protocol type from the drop down list.
•
NAT Type: If you would like to allow the traffic via NAT, then you have to select the option:
NAT Pool: You can associate a preconfigured NAT pool to the rule that you are
o
adding or modifying.
Interface: You can specify external interfaces IP address as the NAT IP address
o
•
Time range: You can specify the time duration during which you will allow certain traffic by
specifying a time-range.
•
Application Filters: If you would like to filter some of the FTP, SMTP commands or filter
HTTP file extensions or RPC program number you can associated the Application Filters to the
rule id.
FTP : Select the FTP application filter if you would like to filter FTP commands
o
SMTP: Select the SMTP application filter if you would like to filter SMTP commands
o
RPC: Select the RPC service filter if you would like to filter RPC program numbers
o
HTTP: Select the HTTP application filter if you would like to filter HTTP file
o
extensions
•
Log: If you would like to enable logging of messages originated from this rule, click enable
radio button else click disable.
•
VPN: Select enable if you want the traffic to go through Broadband Gateway VPN.
82
Start Port: Type the starting value of the port range
End Port: Type the ending value of the port range
Port: Type the port number
Start Port: Type the starting value of the port range
End Port: Type the ending value of the port range
Solwise Asus SL6000 ADSL Ethernet Router User's Guide