Asus SL6000 Setup Instructions page 59

Solwise Asus SL6000 ADSL Ethernet Router User's Guide Chapter 6. Configuring VPN
To add a rule for a VPN connection, follow the instructions below:
1. Log into Configuration Manager as admin, click the VPN menu,
and then click submenu. The VPN Tunnel Configuration
Tunnel
page displays, as shown in Figure 9.1.
Note that when you open the VPN Tunnel Configuration page, a list
of existing rules for VPN connections are also displayed in the lower
half of the configuration page such as those shown in Figure 9.1.
2. Prior to adding a VPN rule, make sure that the VPN service is
enabled in System Service Configuration page.
3. Select "Add New" from the "ID" drop-down list.
4. Enter a desired name, preferably a meaningful name that
signifies the nature of the VPN connection, in the "Name" field. Note
that only alphanumeric characters are allowed in a name.
5. Click on "Enable" or "Disable" radio button to enable or disable
this rule.
6. Make changes to any or all of the following fields: local/remote
secure group, remote gateway, key management type (select
Preshared Key), pre-shared key for IKE, encryption/authentication
algorithm for IKE, lifetime for IKE, encryption/authentication
algorithm for IPSec, operation mode for IPSec, PFS group for
IPSec and lifetime for IPSec. Please see table above for
explanation of these fields.
7. Assign a priority for this rule by selecting a number from the
"Move to" drop-down list. Note that the number indicates the priority
of the rule with two being the highest as one is used by the rule,
59