Add A Rule For Vpn Connection Using Manual Key - Asus SL6000 Setup Instructions

Chapter 6. Configuring VPN
Remote Secure Group
This option allows you to set the remote (destination) secure network to which this rule should apply.
This option allows you to apply this rule inclusively on all computers in the external network. Use the
"Type" drop-down list to select one of the following:
IP Address
Subnet
IP Range
Remote Secure Gateway
Key Management
Two modes are supported: pre-shared key and manual key.
Manual Key
IPSec Proposal Settings
Encryption / Authentication
Operation Mode
Encryption Key
Authentication Key
Inbound SPI
Outbound SPI
6.3.2

Add a Rule for VPN Connection Using Manual Key

62
Solwise Asus SL6000 ADSL Ethernet Router User's Guide
Select any of these and enter details as described
in the Local Secure Group above.
Enter the appropriate IP address for the remote secure
gateway.
Select Manual Key from the Key Management drop-
down list.
Select one of the following pre-configured IKE
proposals from the drop-down list. If "All" is selected,
all the pre-configured proposals will be associated with
existing tunnel and one will be selected automatically
and used by IPSec to communicate with its peer.
All
Strong Encryption & Authentication (ESP 3DES
HMAC SHA1)
Strong Encryption & Authentication (ESP 3DES
HMAC MD5)
Encryption & Authentication (ESP DES HMAC
SHA1)
Encryption & Authentication (ESP DES HMAC MD5)
Authentication (AH SHA1)
Authentication (AH MD5)
Strong Encryption (ESP 3DES)
Encryption (ESP DES)
Authentication (ESP SHA1)
Authentication (ESP MD5)
Enter the encryption key to be used. To enter in hex
start with 0x.
Enter the authentication key to be used. To enter in hex
start with 0x.
Enter the inbound security parameter index.
Enter the outbound security parameter index.
VPN Tunnel Configuration Page, as illustrated below, is used to
configure a rule for VPN connection using manual key.