Asus SL6000 Setup Instructions page 43

Solwise Asus SL6000 ADSL Ethernet Router User's Guide
Allow
Deny
Move to
This option allows you to set a priority for this rule. TheSL-6000 Firewall acts on packets based on the
priority of the rules. Set a priority by specifying a number for its position in the list of rules:
1 (First)
Other numbers
Source IP
This section allows you to set the source network to which this rule should apply. Use the drop-down list
to select one of the following:
Any
IP Address
IP Address
Subnet
Address
Mask
Range
Begin
End
Destination IP
This section allows you to set the destination network to which this rule should apply. Use the drop-down
list to select one of the following:
Any
IP Address, Subnet, Range
Source Port
Any
Single
Port Number
Range
Chapter 5. Configuring Firewall/NAT Settings
Select this button to configure the rule as an allow
rule.
This rule when bound to the Firewall will allow
matching packets to pass through.
Select this button to configure the rule as a deny
rule.
This rule when bound to the Firewall will not allow
matching packets to pass through.
This number marks the highest priority.
Select other numbers to indicate the priority you
wish to assign to the rule.
This option allows you to apply this rule inclusively
on all computers in the external network.
This option allows you to specify an IP address on
which this rule will be applied.
Specify the appropriate network address
This option allows you to include all the computers
that are connected in an IP subnet. When this
option is selected, the following fields become
available for entry:
Enter the appropriate IP address.
Enter the corresponding subnet mask.
This option allows you to include a range of IP
addresses for applying this rule.
The following fields become available for entry
when this option is selected:
Enter the starting IP address of the range
Enter the ending IP address of the range
This option allows you to apply this rule inclusively
on all computers in the local network.
Select any of these and enter details as described
in the Source IP section above.
Select this option if you want this rule to apply to
all applications with an arbitrary source port
number.
This option allows you to apply this rule to an
application with a specific source port number.
Enter the source port number
Select this option if you want this rule to apply to
applications with this port range. The following
fields become available for entry when this option
is selected.
43