Solwise Asus SL6000 ADSL Ethernet Router User's Guide
following fields must be specified:
Contact your ISP for details
Mask. Contact your ISP for details
MPoA Bridge/PPPoE Relay: No further configuration parameters need to be
o
specified for MPoA Bridge and PPPoE Relay Services
Bridge IP Settings: These settings must be specified if any LAN interface is in bridge mode,
2.
or if any ATM interface carries bridged services (MPoA Bridge, PPPoE Relay) - the Broadband
Gateway software will automatically prompt you for the bridge interface settings in this case.
IP Address: Enter the IP address for the bridge interface
o
Subnet Mask Address: Enter the Subnet Mask for the bridge interface
o
Notes
•
If you specify a new service using an ATM interface that has an existing service, the
Broadband Gateway software will automatically delete the existing service and replace it with
the new service
•
If you change your PPPoA/PPPoE password through your ISP, you need to set the new
password for the configured PPPoA/PPPoE service, in order to setup the service successfully
•
The Bridge IP Settings are the same for all Interfaces that are in bridge mode or that have
bridge services running over them
•
RIP Rx is always enabled as RIP is enabled
IP Address: Enter the MPoA Routed service interface's IP Address.
Subnet Mask: Enter the MPoA Routed service interface's Subnet
Chapter 7. The Configuration Pages in more detail
73